Gammon Forum : MUSHclient : General : Using MSP Triggers

Entire forum ➜ MUSHclient ➜ General ➜ Using MSP Triggers

Using MSP Triggers

It is now over 60 days since the last post. This thread is closed. Refresh page

Posted by

Xavaier USA (26 posts) Bio

Date

Tue 14 May 2002 05:19 PM (UTC)

Message

I have made several triggers for mushclient which will enable certain sounds to play when the MSP triggers display.. what I was hoping was that there would be a way to use 1 generic trigger that would take the values from the trigger ie:
*SOUND(action/quaff.wav V=75 L=1 P=50 T=action/ U=http://www.xavaier.com/msp/action/quaff.wav)*

if it would take the action as a variable and quaff.wav as a variable and then play the sound from the trigger like this:

*SOUND(*/* V=75 L=1 P=50 T=*/ U=http://www.xavaier.com/msp/*/*

That would be a great generic trigger if I could get to capture the values and play the sound c:\msp\%2\%3

Any thoughts as in how to make this work!?

Top

Posted by

Nick Gammon Australia (23,173 posts) Bio Forum Administrator

Date

Reply #1 on Wed 15 May 2002 03:34 AM (UTC)

Message

Have you read this post? Doing MSP (MUD Sound Protocol) with MUSHclient. That describes using one trigger to play any number of sounds from MSP.

- Nick Gammon

www.gammon.com.au, www.mushclient.com

Top

Posted by

Xavaier USA (26 posts) Bio

Date

Reply #2 on Wed 15 May 2002 01:22 PM (UTC)

Message

Thanks so much Nick :) sorry I overlooked the obvious.

Top

The dates and times for posts above are shown in Universal Co-ordinated Time (UTC).

To show them in your local time you can join the forum, and then set the 'time correction' field in your profile to the number of hours difference between your location and UTC time.

15,119 views.

It is now over 60 days since the last post. This thread is closed. Refresh page

Go to topic: Search the forum

top