Notice: Any messages purporting to come from this site telling you that your password has expired, or that you need to verify your details, confirm your email, resolve issues, making threats, or asking for money, are
spam. We do not email users with any such messages. If you have lost your password you can obtain a new one by using the
password reset link.
Due to spam on this forum, all posts now need moderator approval.
Entire forum
➜ Programming
➜ General
➜ little problem with SPI at > 1MHz
|
little problem with SPI at > 1MHz
|
It is now over 60 days since the last post. This thread is closed.
Refresh page
| Posted by
| Erik Nyquist
(1 post) Bio
|
| Date
| Tue 18 Dec 2012 01:45 PM (UTC) |
| Message
| Hello, I'm trying to get 2 arduinos to talk to each other over SPI. Now it works just fine, as long as SCK is at 1MHz or lower (DIV16, DIV32, DIV64 or DIV128).
My program is simple, the master sends a string of numbers (0-255) and the slave prints these numbers out in hex, checking them to ensure all bytes have been recieved. If there is a mismatch, it stops.
At 1MHz, it will happily run for hours without a mismatch, but anything higher causes a mismatch within less than a second.
Has anyone got any advice on properly terminating the SCK line? currently I just have jumper wires (very short, not more than 6cm) between the two arduinos.
Surely impedance matching isn't necessary for such short distance/low freq? | | Top |
|
| Posted by
| Nick Gammon
Australia (23,165 posts) Bio
Forum Administrator |
| Date
| Reply #1 on Tue 18 Dec 2012 09:55 PM (UTC) |
| Message
| |
- Nick Gammon
www.gammon.com.au, www.mushclient.com | | Top |
|
| Posted by
| Lakedoo23
(9 posts) Bio
|
| Date
| Reply #2 on Fri 18 Jan 2013 11:14 PM (UTC) |
| Message
| | Hopefully you found the answer, best results I got with SPI was using very thin solid wire and some resistors to reduce the noise on the spi lines. I was able to reach results up to about 43 MHz reliably this was for a SD-card spi interface though. | | Top |
|
The dates and times for posts above are shown in Universal Co-ordinated Time (UTC).
To show them in your local time you can join the forum, and then set the 'time correction' field in your profile to the number of hours difference between your location and UTC time.
16,341 views.
It is now over 60 days since the last post. This thread is closed.
Refresh page
![[Go to top]](/images/gototop.gif)
top
